xHp Stage 1 (8HP)

WHAT IS STAGE 1 xHP FLASHTOOL SOFTWARE?

Stage 1 files are made to enhance mileage and comfort. Shiftpoints are adapted to make optimal use of your engines torque and keep revs low and steady all the time. Gearbox Torque Limiters are removed to open the way for proper operation when paired with tuned engines.

GENERAL FEATURES

CUSTOMIZATION MODULE

xHP features a “Customization Module”, which allows users to change certain settings before flashing an OTS or Custom - Map. The Module injects those user-defined values into every Map before flash. Usage is simple: Just do your settings, save them and flash any map to apply them.
 

CUSTOM LAUNCH CONTROL

Launch Control is a 2-Step process. It gets activated only in S/Sport+ or S/Traction mode of your vehicle. Place your car on a safe, level and straight street. Move your Gear Lever to S and put the car into Traction or Sport+ mode. Now press the brake VERY hard and quickly apply full throttle with the kickdown switch depressed. On vehicles with LC from factory you will see "Launch Control active" on your dash. The amount of boost/torque your car is allowed to build while the brake is depressed is setup with the "Set Launch Torque" slider. After releasing the brake, the Car tries to manage torque and traction along programmed presets which can be tuned up and down with the "Torque Scaling After Launch" slider. 0% is the factory setting and is optimized for stock cars. Tuned cars may need different settings. You are free to experiment with those settings and find your personal best.

* If the DSC is switched OFF completely, LC is not engaged and these setting will have no effect.

* Be aware that especially on AWD vehicles a full load launch with raised Launch Control settings- puts serious stress on all components, eventually including all 4 wheels spinning on the first few meters.